三相全自動測試系統 / Three-phase Fully Automatic Test System with Reference Standard and Integrated C

TS33

The Calmet TS33 portable test system consists of a three-phase reference meter of accuracy class 0.04% (or 0.1%) and an integrated three-phase current and voltage source up to 3x120A/600V

動力工程設備的三相功率校正器和測試儀 / Three Phase Power Calibrator and Tester of Power Engineering Devices

C300B

Three phase, class 0.02 and 0.05 power quality calibrator up to 120A (360A) and 560VAC with programmable power quality parameters. It makes possible to make automatic test of electricity meters, measurement transducers, current transformers and protection relays

功率校正器和保護繼電器測試儀 / Power calibrator and protection relay test set

CP11B

Single phase, class 0.02 and 0.05 power quality calibrator up to 120A and 560VAC with programmable power quality parameters. It makes possible to make automatic test of electricity meters, measurement transducers, current transformers and protection relays

儀表誤差計算器 / Meter error calculator

MPX8

Eight channel meter error calculator together with C300 calibrator is used for testing simultaneously up to eight electricity meters

單相功率校正器 / Single phase power calibrators

C250

Single phase power calibrators with predefined settings. It makes possible to effective adjust and test measuring instruments.

單相功率校正器 / Single phase power calibrator

C200

Series of single phase sources of voltage and current, up to 20A or 100A and set phase and frequency. They make possible to check power analysers clamps up to 1000A. Used also as a phantom load for single phase electricity meters checking.

單相交流電流源 / Single phase AC current source

CC11

The CC11 is single phase AC current source class 0.2 with signal frequency equal to 50/60Hz and with phase shift 0° or 180° relative to the supply voltage. The CC11 enables to generate current in range up to 5A at the supply voltage 85..264V

C300 校正器軟體 / Software for C300 calibrators

Calpro 300

PC software for control of C300 calibrator and automatic testing of power industry equipment.

LabView 驅動程序 / LabView Driver

LabView Driver

National Instruments LabView driver for control C300 calibrator. It makes possible to set voltages, currents, angles, frequency, harmonics, reading analog inputs of C300 and also to make automatic test of electricity meter

MPX8 PC 軟體 / MPX8 PC Softwar

MPX8 PC Softwar

• user-friendly operation
• database for meters and test procedures
• fully-automatic test procedures for meter testing
• continuous monitoring of the test
• tables and graphics for presentation of results
• operator interface available in several languages
• automatic measurements report generation.