簡介
PFP7
The Jenway flame photometers are not supplied with the following accessories but some, e.g. the air compressor and gas regulators, are necessary to run the flame photometer.
我要諮詢網頁資料建構中
網頁資料建構中
The Jenway flame photometers are not supplied with the following accessories but some, e.g. the air compressor and gas regulators, are necessary to run the flame photometer.
A water separator is recommended to remove any residual water from the compressed air supply. The size of water separator required depends on the local humidity. If there is high humidity then the large water separator is recommended.
Gas regulators are needed to regulate the pressure of fuel being inputted into the flame photometer.
A fuel filter is recommended to ensure that no particulates get into the mixing chamber from the fuel supply.
To complement the Jenway range of flame photometers there are several calibration standards offered to enable accurate calibration of the flame photometer. All calibration standards are 500ml unless otherwise stated.
| Ordering Information | |
| Part Code | Description |
| 535 001 | Air compressor (230V/ 50/ 60Hz) |
| 535 002 | Air compressor (110V/ 60Hz) |
| 500 176 | Water separator (small) |
| 500 177 | Water separator (large) |
| 500 093 | Fuel filter |
| 500 178 | Butane regulator |
| 500 179 | Propane regulator |
| 500 180 | Natural gas regulator |
| Calibration Standards | |
| Part Code | Description |
| 025 008 | 1.00mmol/l Li |
| 025 004 | 100mmol/l Na, 100mmol/l K |
| 025 006 | 140mmol/l Na, 5mmol/l K |
| 025 007 | 120mmol/l Na, 2mmol/l K |
| 025 005 | 160mmol/l Na, 8mmol/l K |
| 025 027 | 160mmol/l Na, 80mmol/l K |
| 025 021 | 1000ppm Na |
| 025 023 | 1000ppm K |
| 025 024 | 1000ppm Li |
| 025 025 | 3000ppm Ba |
| 025 009 | 1000ppm Ca |
| 025 171 | Cleaning solution (1 litre) |
| Miscellaneous | |
| Part Code | Description |
| 500 134 | Dust cover |
| 500 019 | Nebuliser |